How to knot your tie

The knot should fit proparly around the collar, but shouldn't be too tight. If the knot of your tie is flat, the knot is probably too large or too loose. Try it again!

Practice makes perfect! Clean hands and a mirror are also desirable. The wide tail of your tie should reach exactly to your waistband or belt when you're finished. The narrow part can just stay loose, unless you prefer to use the extra loop in the back (the passentino). 
Leaving it loose usually gives your look a more stylish and modern feel. Remember, the narrow part may never be longer than the wide part of your tie and it should never be tucked away in your shirt. 
 
Half Windsor
 
   

The Half Windsor is a fashionable version of the Dubble Windsor knot. The knot is a symmetrical and triangular knot. Suitable recommends to choose a wide tie, made of a light fabric. This knot can we worn with every type of collar.
The Half Windsor knot can be created in just five steps.

  1. Keep the tie in a position in which the wide section is about 30 centimeters below the narrow part (image 1).
  2. Fold the tie around and then over, between the tie and collar. Tighten the knot if preferred (image 2, 3 & 4).
  3. Fold the wide part of your tie over the wide part of the knot, from left to right (image 5).
  4. Pull the wide part of the tie through the loop of the neck and pull the tie down (image 6 & 7).
  5. Tighten the tie by pulling at the narrow part, towards your collar (image 8).

Go to our desktop website
menu
Go to Shopping bag